|
Cable Asylum Interconnects, speaker wire, power cords. Ask the Cable Guys. |
|
|
|
Cable Asylum Interconnects, speaker wire, power cords. Ask the Cable Guys. |
|
In Reply to: Idea for Speaker Cable, think it'll work? posted by WayneV on January 9, 2007 at 16:28:14:
While more pricey than the FIM wire, you might consider VH Audio's UniCrystal 18 AWG OCC Copper wire (Ohno Continuous Cast) with FEP Teflon insulation since you would not need to be concerned about the dielectric (as mitch2 mentioned, it's not a good idea to thread bare copper wire into Teflon tubing as done with silver wire). However, the main caveat of a DIY cable project such as this would be a lack of vibration damping material, which is often a critical design factor.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Idea for Speaker Cable, think it'll work? - Duster 11:03:27 01/12/07 (1)
- Did it - oofer 23:28:04 01/15/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
