HELP with Frykleaner hook-up

Cable Asylum

Interconnects, speaker wire, power cords. Ask the Cable Guys.

cporada@cabnr.unr.edu

I'm hoping someone can help me with a couple (probably dumb) questions regarding the proper hook-up to burn in cables and components with the Frykleaner (sorry I'm not electrically inclined, my father-in-law built the Frykleaner for me). To burn in a pair of directional stereo interconnects, should I hook up each single channel run to outputs J2 and J3 for the voltage burn and then connect the other ends to J4 or J5 for the current burn, or should I use J2/J3 as the "positive" terminals and hook up my "red" run to one of those and the "black" run to J4/J5, for the voltage burn and then connect the 2 runs with a female/female adaptor to do the current burn? The same question applies to speaker cables; should both the black and red leads from one run of speaker cable attach to J2 and J3 for the voltage burn and then loop around to attach to J4/J5 for the current burn? If I wish to burn-in my line amp, do I just hook my left and right channel ICs to J2/J3 and run these into the line inputs on my line amp?
Thanks for any help.
Chris

This post is made possible by the generous support of people like you and our sponsors:

Herbie's Audio Lab

Topic - HELP with Frykleaner hook-up - cporada@cabnr.unr.edu 06:54:49 12/31/06 (0)

You can not post to an archived thread.