68.231.156.10
This Post Has Been Edited by the Author
In Reply to: RE: Here is your i meg linear taper pot that we need for the rear sections. posted by Michael Samra on May 14, 2017 at 20:23:38
Mike, do you have a few extra we can "trash"? Usually those waffers have some sort of interlocking grove. However the back case is closed. If you cut open the back on one see if there is any way of connecting the shafts????
Then just connect the two - two gang casings together.
If you have a few extra I'll give it a go. It doesn't need to be the exact values since it's only an experiment in connecting the casings. But remember they may not survive the operation.
Follow Ups: