In Reply to: Since we're talking ramps.. posted by dirtyvinyl on March 29, 2017 at 14:36:56:
On the 68k-ohm grid loading resistors or the 1meg-ohm grid to ground resistor? Jumper wire from 68k-ohm to signal grid?
Most DR had the 68k-ohm resistors on the jacks. Some had them on the board.
That's what I'd look at first.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- bad solder points? - FenderLover 15:13:17 03/29/17 (9)
- RE: bad solder points? - dirtyvinyl 17:16:23 03/29/17 (8)
- Hasn't arrived, yet. - FenderLover 20:37:07 03/29/17 (7)
- You will probably need filter caps soon - Alpha Al 06:57:42 03/30/17 (6)
- Wonder why Gibson didn't use a multi-section cap can? - FenderLover 07:11:16 03/30/17 (5)
- RE: Wonder why Gibson didn't use a multi-section cap can? - Thermionic27609 16:53:58 03/31/17 (0)
- RE: Wonder why Gibson didn't use a multi-section cap can? - Coner 11:12:00 03/30/17 (3)
- RE: Wonder why Gibson didn't use a multi-section cap can? - FenderLover 14:43:20 03/31/17 (2)
- RE: Wonder why Gibson didn't use a multi-section cap can? - Coner 15:54:44 03/31/17 (1)
- RE: Wonder why Gibson didn't use a multi-section cap can? - Thermionic27609 16:55:45 03/31/17 (0)