|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Re: power supply posted by Tom §. on October 30, 2001 at 16:57:56:
Besides knowing what the draw is on the power supply, how does the resistance of a choke come into play and does it have anything to do with the 510 ohm resistance value you had spec'd in the supply? Are there any rules for why you have replaced the resistor that is earlier in the chain (of the power supply) rather than later in the chain (the two 1.8K ohm resistors)?159M 15H, 100ma, 256 ohms, 500VDC
Thanks,
Anand.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- How did you figure that out? - Anand 06:39:22 10/31/01 (4)
- Re: How did you figure that out? - Tom §. 07:27:22 10/31/01 (3)
- Re: How did you figure that out? - Anand 08:40:43 10/31/01 (1)
- It's free. - Tom §. 08:47:53 10/31/01 (0)
- oops... - Tom §. 08:39:32 10/31/01 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]