In Reply to: RE: confused again posted by Caucasian Blackplate on February 13, 2019 at 09:12:37:
I just found a site this afternoon that had the formula for calculating the value of the cathode resistor. I am going to give it a try this evening. It seems like that should effect the plate voltage too, but it wasn't in the formula. It will be interesting to see what happens. I must be missing something else though because the 370 plate volts was measured from cathode to grid. Is there an additional voltage in there I have not taken into consideration?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: confused again - vinnie2 13:29:54 02/13/19 (13)
- RE: confused again - Caucasian Blackplate 15:17:18 02/13/19 (12)
- RE: confused again - vinnie2 15:24:44 02/13/19 (11)
- RE: confused again - Caucasian Blackplate 15:25:29 02/13/19 (10)
- RE: confused again - vinnie2 15:36:38 02/13/19 (9)
- RE: confused again - Caucasian Blackplate 15:40:30 02/13/19 (8)
- Boy howdy,that really made a difference! - vinnie2 06:42:37 02/14/19 (6)
- RE: Boy howdy,that really made a difference! - JKT 08:34:21 02/14/19 (5)
- RE: Boy howdy,that really made a difference! - vinnie2 08:53:30 02/14/19 (4)
- RE: Boy howdy,that really made a difference! - Tre' 07:47:40 02/15/19 (3)
- RE: Boy howdy,that really made a difference! - vinnie2 11:57:20 02/15/19 (2)
- RE: Boy howdy,that really made a difference! - Tre' 14:49:11 02/15/19 (1)
- RE: Boy howdy,that really made a difference! - vinnie2 15:07:00 02/15/19 (0)
- RE: confused again - vinnie2 17:54:34 02/13/19 (0)