I posted last May about a custom 6sn7 preamp that was runnnig too hot and had a few cap failures. Here is an update,So after another failure due to heat(burnt resistors), I took it back to the engineer for a power supply rebuild. Redesigned power supply in a separate box with 5AR4 tube rectification. Preamp box uses 0A2 and 0B2 tube voltage regulators. Runs cool and so far so good.
Thomas
"I've never owned a firearm, but I do have an attack parrot!"
Edits: 08/02/17
This post is made possible by the generous support of people like you and our sponsors:
Topic - Hot 6SN7 Preamp update - Cuernavaca 11:47:16 08/02/17 (7)
- power supply - Cuernavaca 09:28:00 08/03/17 (1)
- Didn't say it was built wrong, just drawn wrong (nt) - Chip647 16:26:01 08/03/17 (0)
- The way the heater supply is drawn in the schematic looks very wrong - Chip647 05:13:23 08/03/17 (0)
- RE: Hot 6SN7 Preamp update - Triode_Kingdom 12:42:14 08/02/17 (3)
- Heater line - FenderLover 18:26:18 08/02/17 (2)
- RE: Heater line - Caucasian Blackplate 19:53:11 08/02/17 (0)
- RE: Heater line - Triode_Kingdom 19:52:36 08/02/17 (0)