|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Shaft Extensions / Panel Bearings posted by Triode_Kingdom on July 10, 2017 at 19:23:55:
while roller-bearing might be nice considering mechanical feedback and such you might find a simple phosphor-bronze bush with a oring groove might be the best solution. A bronze shaft with grove in it might be simpler still and the heavier the moving mass I suspect the better it will feel. Do a small cnc run and ebay the other half.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Shaft Extensions / Panel Bearings - amnesiac 16:14:08 07/11/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
