I finally got around to completing a schematic (less power supply) for a full-featured control amp. I've been working on various aspects of this for some time. It's unity gain (actually about -0.1 dB) with low output Z, switchable tone controls and built-in RCA-type phono preamp. This is a draft schematic only. Some component values will need to be tweaked, particularly the EQ in the phono where I've substituted the Russian 6N2P for 12AX7s.
I'm planning to construct this in a fairly deep cabinet. All tubes will be mounted horizontally on brackets that span the chassis left-to-right. That will allow easy revision or even replacement of any individual section.
As always, comments welcome.
This post is made possible by the generous support of people like you and our sponsors:
Topic - Unity Gain Control Amp - Triode_Kingdom 22:45:49 07/05/17 (7)
- RE: Unity Gain Control Amp - Caucasian Blackplate 13:08:03 07/14/17 (0)
- RE: Unity Gain Control Amp - Eli Duttman 06:17:36 07/06/17 (5)
- RE: Unity Gain Control Amp - Triode_Kingdom 10:45:30 07/06/17 (4)
- RE: Unity Gain Control Amp - Eli Duttman 12:35:54 07/06/17 (3)
- RE: Unity Gain Control Amp - Triode_Kingdom 17:20:53 07/06/17 (2)
- And a question... - Triode_Kingdom 17:31:22 07/06/17 (1)
- RE: And a question... - Caucasian Blackplate 13:13:32 07/14/17 (0)