|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Virtual Umbilical... posted by caffeinator on June 11, 2017 at 06:38:14:
I've been thinking about the same thing. The chassis for this will be constructed from an aluminum extrusion with a 3" X 8" cross-section. I bought a 4' length, so I can cut it to practically any size. If it's about 14" deep, that would allow positioning the PT and power supply circuitry a reasonable distance from the phono section. I'm planning to shield the phono tubes (all 9-pin), and it might also be possible to add a small mu-metal shield around the PT. I think this will work well. :)
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Yes, that's probably what I'll do - Triode_Kingdom 08:54:29 06/11/17 (1)
- RE: Yes, that's probably what I'll do - caffeinator 07:04:27 06/13/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
