In Reply to: Finally ........... it's done. posted by vinnie2 on May 30, 2017 at 08:28:03:
Ok, before making any changes I want to make sure I have it straight this time. I have gone back over the posts and suggestions and this is what I came up with.
1. Per Tre', the 200 ohm resistor needs to be moved to as close as possible to pin 3. The wire from the resistor will still have to go externally to the plate connector on top of the 813 as there is no connector for the plate on the tube socket.
2. The other wires will still all need to be external to the plate connector on the top of the tube because there is no connection to the plate on the tube socket.
The plan is to get the resistors placed correctly, and then I will measure the operating points for voltage and currents to see where we are there.
Does that sound right to everyone?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- update..... - vinnie2 12:41:25 05/31/17 (4)
- RE: update..... - FlaCharlie 14:01:47 05/31/17 (3)
- RE: update..... - vinnie2 14:35:50 05/31/17 (2)
- Maybe My Description Wasn't Clear - FlaCharlie 16:52:47 05/31/17 (1)
- RE: Maybe My Description Wasn't Clear - vinnie2 18:13:35 05/31/17 (0)