In Reply to: RE: voltage drop posted by Tre' on May 31, 2017 at 08:52:51:
Actually the 350 vdc (now 340) was measured between the end of the resistor next to the cap on the 813 and ground, so it should be the same as mearing between the plate and ground. I just realized I really should have checked and written down all the operating points before putting it in place in my system. I will have to try and measure them where it's at I guess, as it is a heavy sucker and the less I move it with my bad back the better.
Edits: 05/31/17
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: voltage drop - vinnie2 08:59:50 05/31/17 (10)
- RE: voltage drop - Tre' 09:04:16 05/31/17 (9)
- RE: voltage drop - vinnie2 09:21:13 05/31/17 (0)
- RE: voltage drop - vinnie2 09:06:46 05/31/17 (7)
- RE: voltage drop - Tre' 09:34:00 05/31/17 (0)
- RE: voltage drop - FlaCharlie 09:20:01 05/31/17 (3)
- RE: voltage drop - vinnie2 09:23:53 05/31/17 (2)
- RE: Correction - FlaCharlie 09:37:37 05/31/17 (1)
- RE: Correction - vinnie2 13:28:03 05/31/17 (0)
- RE: voltage drop - Tre' 09:18:47 05/31/17 (1)
- RE: voltage drop - vinnie2 09:25:36 05/31/17 (0)