In Reply to: RE: 813 triode connection posted by Tre' on April 20, 2017 at 15:50:36:
Actually, on mine the signal comes into G2 (pin 3) and then goes to to the plate through the connection of pin 3 to the plate knob via the 200 ohm resistor. As I said earlier, G1 (pin 4) goes to ground through via a 30k resistor. All four 813's are wired this way and the amp seemed to be working fine in bread board mode. This is what I have on the schem, I will have tso check in the morning and see how it is actually wired on the bread board.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: 813 triode connection - vinnie2 18:10:39 04/20/17 (7)
- Say What? - Triode_Kingdom 08:46:08 04/21/17 (1)
- RE: Say What? - vinnie2 13:12:39 04/21/17 (0)
- RE: 813 triode connection - Tre' 19:56:03 04/20/17 (4)
- RE: 813 triode connection - vinnie2 04:30:42 04/21/17 (3)
- RE: 813 triode connection - Tre' 07:45:59 04/21/17 (2)
- RE: 813 triode connection - vinnie2 13:11:43 04/21/17 (0)
- RE: 813 triode connection - vinnie2 10:19:00 04/21/17 (0)