|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: I would not use wire-wound resistors in grid stopper positions posted by Tube747 on March 5, 2017 at 02:26:20:
CF will do nicely. Buy KOA/Speer parts from Mouser, of an appropriate wattage rating. Remember, Kiwame "audiophile grade" resistors are, in fact, KOA/Speer.Frankly, the fascination with "boutique" parts eludes me. Yes, there are hyper-critical situations where noise factor, low ESR, non-inductive ... matter and a costly part makes sense. Otherwise, good grade (not "bargain basement"), industrial parts yield eminently satisfactory results. Every last one of us is highly vulnerable to the "Emperor's New Clothes Virus". :>((
Eli D.
Edits: 03/05/17 03/05/17
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: I would not use wire-wound resistors in grid stopper positions - Eli Duttman 06:57:57 03/05/17 (5)
- RE: I would not use wire-wound resistors in grid stopper positions - Tube747 21:59:23 03/05/17 (4)
- RE: I would not use wire-wound resistors in grid stopper positions - Eli Duttman 22:38:34 03/05/17 (3)
- RE: I would not use wire-wound resistors in grid stopper positions - Tube747 02:11:52 03/06/17 (2)
- RE: I would not use wire-wound resistors in grid stopper positions - Eli Duttman 05:46:43 03/06/17 (1)
- RE: I would not use wire-wound resistors in grid stopper positions - Tube747 02:59:21 03/07/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
