In Reply to: RE: I would not use wire-wound resistors in grid stopper positions posted by Eli Duttman on March 3, 2017 at 08:48:12:
What about good quality carbon film resistor for grid stopper??
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: I would not use wire-wound resistors in grid stopper positions - Tube747 21:34:51 03/03/17 (21)
- RE: I would not use wire-wound resistors in grid stopper positions - Eli Duttman 22:32:34 03/03/17 (12)
- RE: I would not use wire-wound resistors in grid stopper positions - Tube747 02:26:20 03/05/17 (6)
- RE: I would not use wire-wound resistors in grid stopper positions - Eli Duttman 06:57:57 03/05/17 (5)
- RE: I would not use wire-wound resistors in grid stopper positions - Tube747 21:59:23 03/05/17 (4)
- RE: I would not use wire-wound resistors in grid stopper positions - Eli Duttman 22:38:34 03/05/17 (3)
- RE: I would not use wire-wound resistors in grid stopper positions - Tube747 02:11:52 03/06/17 (2)
- RE: I would not use wire-wound resistors in grid stopper positions - Eli Duttman 05:46:43 03/06/17 (1)
- RE: I would not use wire-wound resistors in grid stopper positions - Tube747 02:59:21 03/07/17 (0)
- RE: I would not use wire-wound resistors in grid stopper positions - dave slagle 09:16:39 03/04/17 (3)
- RE: I would not use wire-wound resistors in grid stopper positions - Eli Duttman 12:19:54 03/04/17 (1)
- RE: I would not use wire-wound resistors in grid stopper positions - dave slagle 12:58:41 03/04/17 (0)
- RE: I would not use wire-wound resistors in grid stopper positions - Triode_Kingdom 11:30:19 03/04/17 (0)
- RE: I would not use wire-wound resistors in grid stopper positions - Tube747 02:27:03 03/04/17 (0)
- RE: I would not use wire-wound resistors in grid stopper positions - FenderLover 21:58:18 03/03/17 (7)
- RE: I would not use wire-wound resistors in grid stopper positions - Tube747 02:26:22 03/04/17 (6)
- Yup! (n/t) - FenderLover 03:04:48 03/04/17 (5)
- RE: Yup! (n/t) - Tube747 19:34:56 03/04/17 (4)
- RE: Yup! (n/t) - FenderLover 22:58:19 03/04/17 (3)
- RE: Yup! (n/t) - Tube747 23:36:36 03/04/17 (2)
- But... - FenderLover 07:25:41 03/05/17 (1)
- RE: But... - Tube747 03:01:04 03/07/17 (0)