|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Re: Alternative posted by fatbottle on September 16, 2002 at 11:57:43:
Hi,Yepp. If mixed and matched from batches and years the actual current draw may be quite of (10% is quite some).
But there is a myriad of series heated valves that could be used as power valves as well (gimme a 'P', gimme a 'L'...).If one has a quad power valve that should have 37.5mA each and 12.6V for bias a 12AX7 filament could be a nice dropping resistor, and the ECC83 will have DC on its filament as well :-)
mvh /Pär
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Alternative - Pär 13:35:34 09/16/02 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
