Tube DIY Asylum

Posted by Tom §. (B) on October 30, 2001 at 16:57:56

In Reply to: power supply posted by Anand on October 30, 2001 at 13:54:22:

Nope. The current draw for that part is about 70mil with the 6N1P installed or 90mil with the 6H30Pi. In both cases the current draw exceeds the current rating of the choke. If I were to put a choke in the power supply, I'd replace the 510ohm resistor with a hammond 159M. This would provide about a 26dB reduction in the power supply ripple.

Tom §.

• How did you figure that out? - Anand 06:39:22 10/31/01 (4)
  • Re: How did you figure that out? - Tom §. 07:27:22 10/31/01 (3)
    • Re: How did you figure that out? - Anand 08:40:43 10/31/01 (1)
      • It's free. - Tom §. 08:47:53 10/31/01 (0)
    • oops... - Tom §. 08:39:32 10/31/01 (0)