|
Propeller Head Plaza Technical and scientific discussion of amps, cables and other topics. |
|
|
|
Propeller Head Plaza Technical and scientific discussion of amps, cables and other topics. |
|
In Reply to: Re: The Scientific Method posted by NEAR SOTA on November 17, 2002 at 14:46:49:
What I appear to be measuring is a 'crossover' distortion in a piece of wire. To be sure, this is only ONE test for differences in wires. This was discovered about 15-20 years ago by Dr. Van den Hul and is on his website. Look it up! For at least 5 years, I have found this measurement just possible with my original test equipment. My biggest problem was noise. NOW, I can signal average the noise out. This is what 'Stereophile' should do as well, when they make amp measurements, especially with tubes. They would find much lower distortion at low levels than what they are showing on their graphs at this time.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: The Scientific Method - john curl 17:01:55 11/17/02 (1)
- Thx for the Clarification .nt - NEAR SOTA 18:51:44 11/17/02 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
