In Reply to: bad transformer posted by Ralph on September 15, 2020 at 08:17:32:
Thanks Ralph.The current transformer has the following secondaries. Are you able to determine what voltages are used for what purpose?
V1 - 6.3V - filament
V2 - 25V - Bias?
V3 - 60V ?
V4 - -120-0-120V ?
V5 - -260-0-260V ?Clark
I had posted this before and deleted it because the subject line was messed up. Unfortunately, right when I did that, Ralph had replied and that got deleted as well. Fortunately, I got his message in email:
V1 - 6.3V - filament high current, about 25 amps to support all the tubes
V2 - 25V - Bias?
V3 - 60V ?
These two are probably bias supplies, one for the top tubes and one for the
bottom?V4 - -120-0-120V ? Definitely output section, you'll need about 2 amps
V5 - -260-0-260V ? Driver section, probably 50mA will do the job.
Edits: 09/15/20
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Dun Mei... - mmcc73 12:03:52 09/15/20 (4)
- transformer windings - Ralph 12:05:50 09/15/20 (3)
- Transformers... - mmcc73 12:16:28 09/15/20 (2)
- RE: Transformers... - Ralph 12:26:51 09/15/20 (1)
- Dun Mei... - mmcc73 14:11:39 09/15/20 (0)