In Reply to: Help, my AtmaSphere M60 blew a fuse!! posted by OTLnewbie on December 23, 2011 at 17:33:55:
Hello,
Sorry to hear about your problem--especially on a holiday weekend. According to your manual, the fuse closest to the IEC plug is the output stage B+. This fuse is a 3 to 5 amp slow blow fuse not a .500. I would replace with what is in there now--which seems to be a 5 amp slow blow.
The cause most likely if I were to guess--is that you have had one or more
output tubes to arc over. This is not such a big deal. I would check the DC offset and if it's difficult to zero out on your meter--then you may have one or more output tubes go south. Just replace the tubes if you have some and if not then do a statistical swap with the tubes that are in there now til you get the DC offset to settle down.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Help, my AtmaSphere M60 blew a fuse!! - Jack Williams 13:21:54 12/24/11 (2)
- RE: Help, my AtmaSphere M60 blew a fuse!! - OTLnewbie 17:04:41 12/24/11 (0)
- RE: Help, my AtmaSphere M60 blew a fuse!! - Lew 15:37:37 12/24/11 (0)