In Reply to: Compression driver to horn gasket? posted by KanedaK on May 15, 2017 at 03:58:31:
without the gasket they is likely going to be a gap or at best a poor transition. The gasket is there to make a seal between the driver and the horn. Don't over tighten there should only be enough pressure to make for a snug fit. If you over tighten the gasket will bulge and distort the flair rate which should ideally be continuous from the driver to horn. Look also that the id of the gasket is the same as the od or exit of the driver which should also match the id of the horn throat. Happy trails.
moray james
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Compression driver to horn gasket? - moray james 12:28:34 05/16/17 (1)
- DIY it? - bare 09:46:22 05/17/17 (0)