In Reply to: RE: More information needed posted by Paul Eizik on February 2, 2017 at 19:02:36:
Hi Paul
I have written some clearifications in Mr steadys post.
My first goal was to eliminate the exit angle missmatch between a 10.4 degree driver exit to a 4 degree horn throat (both 2" in diameter)
I figure I could do this by extending the horn curvature 107 mm in length, and letting the horn pass the driver exit, going inside the driver.
Secondly I figure, why sattle with an 107 mm extension?
Would it be of any gain indreasing this to (lets say 200-300mm) in terms of distorsion of cutoff?
Data:
The horns are 200 Hz cutoff tractrix (approx 600 i length and diamter). The horn throat are 2"
The Radian 750Pb is a 2" exit driver with 10.4 degree exit angle (about 1" Deep). It has a 3" voice coil
I am currently using a single serial cap making a very shallow x-over point at 350Hz. This was chosen by hearing rather than measuring. I have tryed several passive and active x-over configurations, but also digital (MiniDSP) -variants. But simple filters sounds best in my ears.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Sure information supplied - pix 01:00:16 02/03/17 (1)
- RE: Sure information supplied - Paul Eizik 11:49:25 02/03/17 (0)