Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Musical Fidelity A3CR Preamplifier Volume Control posted by Jay Buridan on February 7, 2023 at 10:20:01:
Measure the voltage at the IR remote receiver sensor (usually around 2.5 - 5 Vdc) for TSOP package. Typical IR sensor datasheet below. If you cannot measure anything, then it has to be the PSU. IME, I never had an IR sensor that died on me unless you accidentally or purposely exceeded the specified Vs rating value.
Of course, eliminate the obvious first like battery of the remote, resetting the unit Off and On, remote control is line of sight to the receiver, etc.
Edits: 02/07/23 02/07/23
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Musical Fidelity A3CR Preamplifier Volume Control - amandarae 15:32:26 02/07/23 (0)