|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Problems of Renewing Capacitors posted by wilhelm on January 4, 2019 at 17:55:04:
The large PS caps of, in this case, 36000uf have a build tolerance of +-20%, typically.
Even a higher spec and more $$$ 10% cap could possibly actually be lower in value than the smaller 'value' which replaced it.
I'd make sure the NEW caps were 105c rated IF the origianls were so spec'd while if they were 85c rated, than THAT would have probably been OK, as well.
Too much is never enough
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Problems of Renewing Capacitors - pictureguy 15:39:51 11/30/20 (4)
- RE: Problems of Renewing Capacitors - mcgjohn@yahoo.com 09:55:06 12/01/20 (3)
- RE: Problems of Renewing Capacitors - LtMandella 13:33:45 12/01/20 (1)
- Nichcon capacitors and counterfeits. - Cougar 18:58:14 12/13/20 (0)
- RE: Problems of Renewing Capacitors - pictureguy 10:55:05 12/01/20 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
