|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Amp/Balanced headphones posted by PAR on July 26, 2017 at 06:44:36:
Since our preamps can drive headphones in precisely this manner.
The trick is, ignore pin 1 on the 3-pin XLRs. The output of a balanced source should occur between pins 2 and 3 since ground is ignored and is not part of the signal (if not then its not really as balanced as the manufacturer is claiming). At this point the hookup is obvious.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- We do this a bit - Ralph 09:34:39 07/26/17 (3)
- RE: We do this a bit - PAR 11:12:44 07/26/17 (2)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
