Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Power-on funtion of amplifier on the fritz. posted by Duster on July 12, 2017 at 17:42:09:
I would also check for dc offset at the speaker terminals. put your MM on dc and on the lowest range, let the amp warm up and then take a measurement at both terminals..
Should be less than say 20Mv this may be a dc offset problem certainly from the first episode it is suspicious. Other than that it could be anything like high ESR caps shorting the supply , failed rectifier or bad relay or latching cct for the relay soft start.
Needs a tech
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Power-on funtion of amplifier on the fritz. - AJ 07:05:07 07/14/17 (0)