Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Clean tube pins and sockets... posted by Jonesy on February 16, 2017 at 14:44:09:
Thanks Jonesy. I am certainly not an electonics expert but I dont think a bad tube on either side would cause hum in both. I have cleaned the pins and sockets and the 6v6 are new. The 6922's are ElectroHarmonix and the were in the unit when I purchased it. I was told they had about 100 hours on them. I have two other sets of 6922's and it doesnt really change when I swap them out.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Clean tube pins and sockets... - Try1256 15:53:10 02/16/17 (0)