|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: NAF amp failure update posted by Jerry P on August 10, 2012 at 05:51:08:
The bulb type solder suckers are kinda a POS... ones such as this one from PartsExpress are better: http://www.parts-express.com/pe/showdetl.cfm?Partnumber=370-030
Other than clearing thru holes, I've never felt the need for a desoldering iron, and if I did, I would get a powered vacuum type such as a Hakko 808, etc. It is easy enough to hold the iron with one hand and the solder sucker with the other. Then take some needlenose pliers and the iron, and remove the component lead while heating a bit.
I prefer the Edsyn type, such as this one:
http://www.amazon.com/Edsyn-Desoldering-Pump-PT109-Soldapullt/dp/B000PDQJYI/ref=sr_1_4?s=hi&ie=UTF8&qid=1344616589&sr=1-4&keywords=edsyn
If you have a Fry's nearby, they carry them in stock.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: NAF amp failure update - pars 09:33:05 08/10/12 (1)
- RE: NAF amp failure update - Jerry P 11:26:39 08/10/12 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
