Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
Hi all,
don't know if it's the right forum to post this but...
I use a DIY Kaneda preamplifier (not built by me, I'm totally unable to build anything at this point) and a Technics SE-A5 power amp. Both circuits are pure DC and that leaves me a little worried because I don't really trust the preamp's reliability... The power amp is supposed to cut if DC is detected but I don't really trust that either (amp is from 1981).
I've been reading advices on the internet to put some caps at the preamp's output. Granted, I could use the amplifier "normal" input (as opposed to the DC input, there's a choice of both) but I'd prefer to chose a great quality output cap rather than use the amp's probably rather mundane entrance caps.
Question is: I have no idea wich type and wich value I'm supposed to use...
thanks folks!
This post is made possible by the generous support of people like you and our sponsors:
Topic - Capacitor between DC amp and preamp? - KanedaK 04:57:44 02/29/12 (5)
- RE: Capacitor between DC amp and preamp? - rick_m 07:56:19 02/29/12 (3)
- RE: Capacitor between DC amp and preamp? - KanedaK 18:59:26 02/29/12 (2)
- RE: Capacitor between DC amp and preamp? - rick_m 21:11:32 02/29/12 (1)
- RE: Capacitor between DC amp and preamp? - KanedaK 03:52:18 03/02/12 (0)
- RE: Capacitor between DC amp and preamp? - bwb 07:33:57 02/29/12 (0)