Planar Speaker Asylum

Posted by Davey (A) on November 25, 2021 at 07:59:40

In Reply to: RE: "Anyone here seen a .7 crossover schematic yet" ... posted by andyr on November 25, 2021 at 02:37:42

You DO need to know what the component values are because the crossovers are setup with different filter points for low-pass and high-pass. (This is especially true of the older models with parallel crossovers.)

You can't just select a single crossover frequency for both portions and vary it. You'd end up with a hugely bumped up midrange response.

Dave.

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2021, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---