|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: Takes me back to '81 posted by Brad225 on August 15, 2022 at 16:11:48:
Roy is the resource I used to update my interfaces.
The panels are wired in parallel - three from each panel. With later interfaces like the ones I use, the signal cables are terminated with a curved spade connector while the bias terminates with a pin. I'm traveling and don't have easy access to internal pics but will be happy to post them later this week. I also have a schematic. Another great resource is found on DIY Audio where another ex-employee named Andrew goes by The Acoustat Answer Man and has been helpful to many.
There were many variations on the interfaces, some of which were identified a being a "Red Medallion" or "Blue Medallion". You may be aware there were one, two, three, four, six and eight panel variations and some like the 2+2, 6 and 8 were stacked sets.
So long as the transformers are good, the rest of the components can be easily replaced.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Takes me back to '81 - E-Stat 18:12:15 08/15/22 (2)
- RE: Takes me back to '81 - Brad225 20:15:44 08/15/22 (1)
- RE: Takes me back to '81 - Brad225 12:45:18 08/22/22 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
