Tech Square

Technical and speculative discussion of amps, cables and other topics.

Return to Tech Square

Message Sort: Post Order or Asylum Reverse Threaded

replacing a silicon rectifier with a diode

166.249.202.159
Posted on September 9, 2012 at 16:08:21
Camrahnbay
Audiophile

Posts: 407
Location: DESERT SW
Joined: January 15, 2009
 Could someone please explain how this is done and if there are other parts that have to be used...like capacitors or resisters and if so in what configuration?
Thank you

 

Hide full thread outline!
    ...
RE: replacing a silicon rectifier with a diode, posted on September 12, 2012 at 09:35:28
Lee of Omaha
Dealer

Posts: 1800
Location: Omaha NE
Joined: September 8, 2006
 I assume you mean replacing with a tube rectifier such as a 5U4. First, you're going to need a supply for the heater. You can use a filament transformer or a DC supply. A DC supply will need to float, so you're better off using a filament transformer. Chunky rectifiers such as the 5U4 draw 3 amps at 5 volts. You will get a greater forward voltage drop across the tube than a silicon rectifier.

There is a nearly constant voltage drop of 1 volt or a little less across the silicon diode, but the voltage drop across the tube increases with current. So your power supply with a tube will have lower voltage and greater impedance than with a solid state device. You will also have a bit of built-in time delay in your high voltage supply as the cathode needs to heat before it starts emitting. A directly-heated rectifier such as the 5U4 will have only a 1-2 second delay, but an indirectly heated tube will have a delay of 8-12 seconds.

If your circuit was designed for solid state, I can't see a good reason to redesign it, with one exception. By paralleling a tube with silicon you avoid the 0.6 volt or so turn on delay every half-cycle. The silicon does the "heavy lifting" while the tube is just there to get things started. You will still need the filament supply. The tube, since it does so little, should last a long time. As much as I like the idea, I haven't done it, and suspect it will be little "bang for the buck."

Good luck.

 

RE: replacing a silicon rectifier with a diode, posted on March 22, 2013 at 12:07:41
pictureguy
Audiophile

Posts: 22597
Location: SoCal
Joined: October 19, 2008
 Diodes.....solid state....ARE made of Silicon.
You can make 'em....old school, out of copper oxide or Selenium, but I havent' seen one in a long time.
I suppose you could also use Germanium, another semiconductor. Also, Gallium Arsenide (GaAs) must have a diode in there somewhere or else why bother?

But 99% of 'diodes' in use for home stereo will be either Silicon or Vacuum........
Too much is never enough

 

Page processed in 0.046 seconds.

[ Top Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]