Amp/Preamp Asylum

Looking for a new Amp or Preamp? If you're after tubes, post over here.

Return to Amp/Preamp Asylum


Message Sort: Post Order or Asylum Reverse Threaded

Voltages for connecting ds18b20 to Edison breakout board

113.89.233.246

Posted on June 20, 2017 at 01:46:48
yang1988
Audiophile

Posts: 1
Joined: June 20, 2017


It appears that the upm library provides support for reading temperatures from a ds18b20 on an Edison via uart. They also provide this hookup diagram. However, it looks like the ds18b20 can only operate at 5V while the UART TX and RX on the breakout board are at 1.8V (table 28). This upm diagram seems to suggest they should be directly connected though. I am hesitant to try it for fear of damaging the board or module.

this is the date sheet: http://www.componentschip.com/details/Maxim-Integrated/DS18B20.html

Do I need to step the voltage up and down between the Edison uart and a 1-Wire bus?

If so, what would be the appropriate way to do that?

 

Page processed in 0.012 seconds.