|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
24.197.204.81
In Reply to: RE: 300hz is too high posted by KanedaK on February 05, 2017 at 06:58:06
That's happened to everyone at least once! Don't sweat it. We all waste more money than we should on this obsession. How much are they worth, a few bucks? You could keep them around for trying as bypass of other caps.
Eventually, if this configuration works properly and sounds good, you will need to spend serious money on really good copper foil caps because the entire mid/high signal will pass through them.
What is the configuration of the current passive filter? Please supply complete, specific information. Why do you want to add another filter if you're already shelving low freq's by 6db/octave below 400hz?
Peace,
Tom E
berate is 8 and benign is 9
Follow Ups:
I want to add another filter because the 400hz high-pass is after the amplifier.
The amp is fed full range and I wanna remove some low frequencies to put less stress on it.
All is well, I've just ordered some Russian PIO caps, apparently the "best" ones.
I'm curious to try them - besides filtering the lows, they will most likely sound better than the Arcotronic caps I have now.
You didn't mention the value of the PIO caps you ordered. If you use the .033uF (that's 33 nano) as I recommended, the input to your amp will be down 1/4db @ 400hz, 1/2db @ 300, 3db @ 100, 9db @ 50, 15db @ 25hz, so that is a decent reduction of low freq energy without significantly impacting existing filter slopes, although the response of the speakers will be affected somewhat in that their lowest frequencies will be reduced as well. This will probably have a greater impact on perceived clarity than reducing input to the amp. All small speakers distort when tasked with reproducing low frequencies, whereas most decent amplifiers do not.
Depending on what it is now, you might need to tweak the response of the bass xover/amp by raising the xover point (not terribly difficult), adjusting the slope (pretty complicated), or merely increasing the volume a bit (easy!) to compensate for the increased roll off of low freq's from the mids.
I doubt that Russian PIO is the best because there is no such thing (I assume that's why you used quotes), although they may be the best value. Improving on the sound of Arcotronics caps is no tall order, so you should be pleased. If you care to eventually invest more, I guarantee you would be even more pleased with copper foil.
Peace,
Tom E
berate is 8 and benign is 9
When my speakers were fully passive, they relied more on natural roloff of the various horns to create the slopes, than on the first order crossovers - mainly there to stop the robust Atlas midrange driver from frying. So I don't think whatever happens lower than 400Hz is making really much difference ( wére not talking extreme slopes here).
The reason I went active on the low pass is because I changed bass horns, and the new ones don't roll off so quick above 400Hz - I had to have a steeper slope than 6dB/oct because it sounded like crap.
But my 8 watts amp is now driving the high pass only and there's 50watts on the bass horns, and I like the added power for sure!
But yes I ordered 0,033uF as you said :)
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: