|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
68.231.156.10
In Reply to: RE: Working in a bedroom system, Bel Canto / Harbeth, 2nd system setup. posted by bullethead on July 08, 2017 at 12:56:15
You're a nice guy and I like ya. But if you troll that question again I'll have to kill ya.
It's obvious that topic should never be discussed here again. Take it over to the cable forum.
Follow Ups:
I wasn't paying attention to infighting, sorry about that. That's crazy everyone going bezerk on that thread.
Question was merely about the piss poor setup I have, found a carpet for the wall but lost my hammer but I have nails.
carpet is all I can do now with speakers so close to wall, and use the tone controls on the Sonos Connect.
Hi bullethead,
At risk of further contention, I recommend AudioQuest FLX 14/4 as an affordable upgrade vs. 16 AWG zip cord speaker wire. I think you will enjoy the difference.
http://www.audioadvisor.com/prodinfo.asp?number=AQFLXSLIP4
The proper wiring scheme for a cross-connected star quad configuration for your Harbeth loudspeaker is shown here:
thank you, I already ordered a pair of Blue Jeans cable, at amazon link below: (big fan)
I have to say the tone controls on the Sonos are working good, I just set the bass to 1/2 until I get the rug hung behind the speakers on the wall.
I was getting very boomy bass, that is not there anymore, with a little more treatment it should be ok.
That should do the job better than 16 AWG zip cord. Looking forward to seeing your evaluation if you decide to post your impression in the forum.
Cheers, Duster
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: