|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
174.70.97.170
Ok forgive me I'm still a little green when it comes to my internals.
My question is are there any caps here that would benefit from a Black Gate NX 50v .47uf bypass? (I have a bunch of them)Goodness my eyes are getting old that's hard to see. Use Ctrl+ to zoom in
Edits: 02/17/12Follow Ups:
.
Replacing the electrolytics with oil/film caps would be a good move if you have the room
.
Absolutely, thats a project I'll slowly get to some time later on down the road.
HOLY COW!!!
I just replaced all the caps on the filament reg board (el cheapo "Lelon") with 4700uf Black Gate Std's and the 220uf caps with BG NX's which I've byspassed with the tiny 0.47NX's
It has totally transformed the sound from great, to absolutely Stunning!
Breathtaking in fact, My jaw has been on the floor for two days...
Now does anyone have experience with replacing Elna's with BG's?
Do I leave the 220uf silmics around the 300B's or replace these too with BG std's? Or will this not make much of a difference.
And also around the 5687's I have Cerafines should I change these out too for std's?
Cathode by pass for the driver
Yes I was curious about that, but at the same time I was thinking it ridiculous, the only reason I asked was because of this article.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: