|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
73.77.75.217
In Reply to: RE: Show your Pi case(s)! posted by E-Stat on June 07, 2017 at 12:50:48
E-Stat, where did you get that case?
Follow Ups:
Follow the link found here .Be careful if you post pictures. If you test the unit's operation on top of your DAC for more than an hour (mine was there initially for two), you'll find individuals who will quickly criticize the location. :)
At the expense of repetition, this case includes three small heat sinks and has holes for mounting. Expect to spend a good hour with assembly. Each layer of acrylic has protective sheets on either side. You'll need an X-Acto type knife (I used a cheapo package cutter) to pull back a corner of the film for removal. Then you stack the layers one by one. Mine included a diagram which identified where each piece goes. My Digi+ board required a little bit of trimming of two layers to accommodate the opening for both output connectors. No biggie. The first pic shows that area.
I would buy it again.
Edits: 06/11/17
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: