|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
195.228.210.227
In Reply to: RE: As I always advise in situations such as this,... posted by Lew on September 27, 2015 at 13:19:47
This weekend I have been dealing with almost the same problem on my humble diy M60. I measured the voltages on the sockets of all tubes (tubes taken out). Everything was fine except the grid voltage on V4 (-285). I suspected there is a fault in 5K trim pot, replaced it, and the problem disappeared.
Follow Ups:
I fixed my neighbor's Novacron, which had a problem with "low power output" (much like that of the OP in this thread), and it also turned out to be due to what appeared to be an intermittent problem with a bias pot, which resulted in operating one bank of 6C33Cs in near shut-off conditions. (Bias voltage was around -80V, which will pretty much turn off a 6C33C that sees the typical plate voltage in a Novacron.) I gave the pot a few turns in both directions, then re-set the bias, and that alone seemed to cure the problem, which has not recurred. Either that or he had just erred in setting bias. He seemed to know how to do it, so I tend to think the pot was faulty, but I really cannot be sure.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: