|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
76.28.209.43
In Reply to: RE: Anybody have any experience with Furutech FT-111 RCA's? posted by bcowen on March 31, 2017 at 15:15:22
Have you found information about leaving one conductor un-insulated? Perhaps a link to share? I recommend using cotton tubing for both the signal and return conductors, not for the sake of adding another layer of insulation, but for the sake of a more precision twisted pair, since the form of each loop area may be skewed due to the lack of a mirror image of the two opposing conductors. A consistent mirror image twist ratio along the entire length of a twisted pair cable is what provides EMI/RFI noise cancellation.
Follow Ups:
No, haven't found or read anything about it. Just my random and probably laughable idea trying to be creative. Still have some more thinking to do on that approach, and what I wanted to do most right now was try out this gold wire. So my first try will be with a more conventional geometry. I'm using 20 gauge Neotech PCOCC solid core copper with PTFE insulation for the negative lead, and the gold wire for positive. I figured the Neo's insulation was good enough for both wires (for an interconnect application), so I'm leaving the gold wire bare naked. Techflex sleeve will go around it all, and I may run a PTFE heat shrink over both wires before sleeving it. Haven't decided yet, but it's Final Four time so it'll have to wait. :) Go Tarheels!!!
Not laughable at all, bcowen. It makes perfect sense from a minimal-mass POV. Your twist pattern looks to be very good, but might not provide the best noise cancellation properties since the two opposing wires are not mirror image. However, the cable might sound very good, since there are no hard rules about DIY experiments. If you have some PTFE heat shrink that's handy, I would choose to use it as a DIY cable jacket to provide a level of cable resonance control and to keep the twisted pair from loosening over time, which is important.
Thanks for the input Duster. I was aiming more for a minimal dielectric result by going with the bare wire. All dielectrics seem to impose some signature on the sound, so I figured less was better while still insulating sufficiently. Not even sure what is in this gold wire. May prove to be awesome......or a complete disappointment.
Been looking at this Jupiter cotton insulated wire. Might have to give it a try too. Should be easier to twist it much closer to a mirror image.
I expect it will sound very satisfactory, since I like what I see, bcowen.
I'm a tough critic at times, but I have an open mind to well-considered DIY experiments like yours!
I look forward to a detailed report, since your own evaluation is the point...
Cheers, Duster
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: