|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
104.14.166.252
In Reply to: RE: Check these out posted by mitch2 on December 28, 2016 at 18:40:19
Mitch,
Those are awesome! And priced right too. I've never seen those before, so many thanks for the link. The model you linked to will only accept 12 gauge wire (and I have two 12 gauge wires to shove in there), but the ones below will work nicely. Love the design on these all the way to the Torx setscrews.
I bought a few dowels yesterday to try out Duster's idea on the AQ plugs, but haven't had a chance to install them yet. I may order a set of the Furez anyway just because they're so well thought out. Thanks again for the link.
Follow Ups:
BTW, I suggest wrapping the wooden dowel insert with a layer of PTFE plumber's tape before you insert it into the tip of the BFA connector.
The Teflon tape wrap may provide a level of vibration control, while also allowing a snugger-fit based on how many layers are wrapped around the dowel.
I stumbled across them because I was looking for spades that would accept a huge wire size for a DIY cable I was trying out, and they sell them.
I ended up buying spades and a bunch of the bananas because they were so inexpensive.
I still like my Furutech spades best, and I mostly use the Furez bananas for my HT set-up, but I do have the bananas you are looking at. They fit my amp's WBT posts very snug. I suspect you will be satisfied. My only (minor) issue is the T6 torx size they use is quite small and susceptible to stripping - I purchased a few extra of the small screws. If you are careful and tighten incrementally it should be fine. They will even sell you a torx driver (screwdriver type) for just over $3 that fits their torx stuff.
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: