Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: No, because... posted by anumber1 on October 3, 2006 at 17:12:14:
That implies that the typical "how much gain do I need?" question really ought to consider loading; at least for LOMC ... I assume for a MM the 47k load dwarft cartridges's impedance.So for a 103 with 100 ohm loading (assume an active phono stage) the load "sees" about 70% of the voltage (I'm assuming the coil impedance of 40 ohm)?
Is that about right?
No Guru, No Method, No Teacher
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Ah, so MC cartridge output is measured (for specs) open? Didn't know that, Thanks. - bjh 17:36:52 10/03/06 (5)
- Try this article... - anumber1 19:28:18 10/03/06 (2)
- Thanks. nt - bjh 22:22:39 10/03/06 (0)
- Plus a bit more... - anumber1 19:48:53 10/03/06 (0)
- DL-103R - JRags 17:55:46 10/03/06 (1)
- Re: the output voltage on the printout - Paul Tobin 07:49:39 10/04/06 (0)