Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
Would have to be fairly accurate to match the raised center portion of the platter. Who knows why certain manufactures even did this? Thanks, in advance, for the help.
This post is made possible by the generous support of people like you and our sponsors:
Topic - How would you cut a 9.5 cm hole in the center of a rubber mat? - viridian 15:56:33 12/22/21 (16)
- Laser cutting - flood2 12:33:41 12/23/21 (4)
- Happy holidays, Anthony and thank you. Must be Summer in your part of the world about now. nt - viridian 15:19:26 12/23/21 (3)
- RE: Happy holidays, Anthony and thank you. Must be Summer in your part of the world about now. nt - flood2 15:34:47 12/23/21 (2)
- Thanks! I needed that one. Nt - viridian 10:12:24 12/24/21 (0)
- Boy, that's an old surfboard. nt - alaskahiatt 22:55:00 12/23/21 (0)
- RE: How would you cut a 9.5 cm hole in the center of a rubber mat? - ChesshireCat 12:03:16 12/23/21 (2)
- Thanks for the freezing tip. I should know that being from Alaska and also - alaskahiatt 23:01:37 12/23/21 (0)
- Thank you for the tip Gary. nt - viridian 12:29:29 12/23/21 (0)
- Unlimber the 12 ga. )MT( - J. S. Bach 04:06:09 12/23/21 (0)
- You could try a tool like this . . . - alaskahiatt 17:37:46 12/22/21 (3)
- RE: You could try a tool like this . . . - Ogsarg 09:03:08 12/24/21 (1)
- Good idea. Thanks. nt - alaskahiatt 09:08:43 12/24/21 (0)
- That is really cool, thank you! nt - viridian 18:01:48 12/22/21 (0)
- RE: How would you cut a 9.5 cm hole in the center of a rubber mat? - John Elison 17:09:30 12/22/21 (2)
- RE: How would you cut a 9.5 cm hole in the center of a rubber mat? - Joe Backer 17:32:58 12/22/21 (1)
- Joe, I was thinking the same as John. That link is to a 9.5 mm punch, need cm. Nt - viridian 17:59:01 12/22/21 (0)