Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
I need to make the brass counterweight under the platter of my Ariston RD40.
Considering using a row of brass washers on a metal rod until the appropriate weight (unknown) is achieved.
Any suggestions are welcome.
That's not my table in broken down photo.
Your interest may vary but the results will be same. (Byrd 2020)
I can't compete with the dead. (Buck W. 2010)
Cowards can't be heroes. (Byrd 2017)
Why don't catfish have kittens? (Moe Howard 1937)
This post is made possible by the generous support of people like you and our sponsors:
Topic - Need to make a counterweight - Ariston RD40 - Byrd69 07:11:17 10/22/20 (14)
- Here's one approach - Bill Way 09:48:28 10/23/20 (12)
- RE: Here's one approach - Byrd69 16:40:43 10/23/20 (9)
- "O rings on both sides could keep them in place" I used nuts and washers on my counterweight-less Syntec ... - J. S. Bach 04:09:48 10/24/20 (0)
- RE: Here's one approach - pictureguy 16:47:55 10/23/20 (7)
- RE: Here's one approach - Byrd69 18:14:11 10/23/20 (6)
- RE: Here's one approach - pictureguy 19:49:02 10/23/20 (5)
- Dang...the hole isn't threaded - Byrd69 10:22:26 10/24/20 (4)
- RE: Dang...the hole isn't threaded - rivervalley817 11:05:49 10/24/20 (2)
- I overthink buying a bag of oranges - Byrd69 12:09:19 10/24/20 (1)
- RE: I overthink buying a bag of oranges - rivervalley817 12:34:03 10/24/20 (0)
- RE: Dang...the hole isn't threaded - pictureguy 10:57:06 10/24/20 (0)
- RE: Here's one approach - rivervalley817 10:00:21 10/23/20 (1)
- RE: Here's one approach - Bill Way 13:06:15 10/23/20 (0)
- RE: Need to make a counterweight - Ariston RD40 - Story 02:18:52 10/23/20 (0)