|
General Asylum General audio topics that don't fit into specific categories. |
|
|
|
General Asylum General audio topics that don't fit into specific categories. |
|
In Reply to: RE: Another floor question posted by SpotcheckBilly12345 on June 12, 2017 at 08:24:44:
From personal experience. Lay thick mil plastic over the concrete. Then lay 3/4" tongue and groove 4' x 8' plywood down. It must be secured to the concrete. We used a Hilti gun. Then lay tar paper over the plywood. Lastly install your hardwood flooring. Yes, you will have to cut the bottom of your doors. Never had any problems. It's not cheap and takes a lot of work, but it can be done. :-)
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Not true, but must be done properly - vinyl survivor 18:15:04 06/12/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
