Home Digital Drive

Upsamplers, DACs, jitter, shakes and analogue withdrawals, this is it.

RE: DSD Numbers.

OK, so you play an SACD in the player with output sent via HDMI to the AV receiver. The DSD layer on the SACD is selected in the player and either stereo or MCH is also selected as is the requirement at the time ( maybe both via the receiver's 2 way communication with the player, see below).

The AV receiver takes the DSD data and converts it to analogue. The analogue output is sent via the pre out jacks to the stereo amp feeding the front L and R speakers. The analogue output for the remaining channels is amplified by the AV receiver and used to power front centre and rear L and R speakers.

Is that your system's connectivity?

If correct, so as far as I can tell from the manual, you can remotely select the configuration of the HDMI connected player via the receiver (but it's still an output from the player) and configure aspects of the speakers. The receiver is not itself outputting any DSD. It may do this using its connectivity to a Zone 2 component i.e. another system in another room but you haven't mentioned this.

So the display is showing DSD input from the player and that the output of the receiver is for a combination of 3 speakers front and 2 speakers rear. However you are actually not using all of the amplified channels but are taking 2 of them via the pre out.

Does this make sense?



Edits: 02/21/17

This post is made possible by the generous support of people like you and our sponsors:
  Atma-Sphere Music Systems, Inc.  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.