In Reply to: Looking for speaker cable termination suggestions. posted by pkats on February 4, 2012 at 22:36:34:
Wrap one of the 14 AWG wires around the other, leaving enough length of the first wire (that's not wrapped) to be able to fit into the BFA connector, all by itself -- solder the wrapped wire onto the first wire making sure not to allow any stray solder to run onto the section of bare wire that will be placed inside the connector. You may wish to slightly flatten the bare 14 AWG wire where the set-screws make contact with it in order to obtain a firmer grip.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- A simple solution... - Duster 13:45:04 02/06/12 (0)