|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
In Reply to: Re: Ignorant speaker cap questions. posted by Bold Eagle on December 28, 2003 at 09:35:15:
At last count I have 12 pairs of conventional speakers in operation somewhere in the house plus a couple more pair in a closet. So I'm not really in need of yet another conventional design.
Bose has this other all-in-one deal thats not a Wave radio or three-piece--maybe that would be a better starting point. Many small console stereos from the 60s had side-firing low-range units, and then mounted the other drivers toward the front. If I made a single cabinet about 24 inches long I could mount the woofers in either end, and directionality would be enhanced as they would be aimed in opposite directions. Then I could mount the other drivers in two small separate boxes that could sit atop or near the woofer cabinet not a long ways from the woofers.
Hmm... kinda an updated console.
Follow Ups:
Side firing or off axis firing gives the effect of removing the higher frequencies without the use of any crossover. This would let the lower frequency, which has a lesser directional quality, pass while shooting the more directional higher tones into no where land, or off a wall or something. I think this was the early version of a 6th order bandpass. Bose really mastered this trick early on and did a very good job using 4 inch drivers.
Consider downward firing the woofers. Or even rear and forward.
c
Kind of a combination sub-woofer speaker stand.
You cuuld then aim the directional speakers easily or even tilt them back slightly.
Some interesting ideas.
Bill
....
If it doesn't work you can remove the woofers and do the saw people in half magic act with it.
Bill
This post is made possible by the generous support of people like you and our sponsors: