Posted by Jean-Claude (A) on September 29, 2006 at 13:51:38

In Reply to: Re: Kit 1 posted by pet on September 29, 2006 at 09:08:15:

Hi,

In which extent is it a vaste improvement..I currently have the signature KIT one...?

Regards

Jean-Claude

• Re: Kit 1 - pet 14:36:47 09/29/06 (4)
  In Reply to: Re: Kit 1 posted by Jean-Claude on September 29, 2006 at 13:51:38:

  
  I was asked to write a review of my upgrade by a fellow member but I don't think I can at this time , I had only upgraded the trans in late March of this year. My kit was built back in 1999 , I had upgraded all the internal components thru the years , including copper foil caps , cerafine filament caps , AN-v cables , tantalum resisotrs , etc.... but the C-core trans was the only upgrade , IMHO , that had an immediate improvement sonically. I hope this was helpful , Jean-Claude .
  
  

  ---

  • Re: Kit 1 - Jean-Claude 23:19:53 09/29/06 (3)
    In Reply to: Re: Kit 1 posted by pet on September 29, 2006 at 14:36:47:

    Pet,

    This is what I feared ! I built my KIT last year (standard version)and I upgraded the Driver board (harwired / copperfoil / tants), BG for filament board, BG for 300B, An-V between drvierboard and Elma switch, chrome shroud covers.
    But I am not sure to have enough room in the chassis to install the double C-Core trans ?

    Jean-Claude
    
    

    ---

    • Re: Kit 1 - beto1 04:56:58 09/30/06 (0)
      In Reply to: Re: Kit 1 posted by Jean-Claude on September 29, 2006 at 23:19:53:

      Hi Jean-Claude,
      Brian has designed a 35mm wider chassis to use with the double C TX.
      Regards,
      Beto
      
      

      ---
    • Re: Kit 1 - pet 04:42:20 09/30/06 (1)
      In Reply to: Re: Kit 1 posted by Jean-Claude on September 29, 2006 at 23:19:53:

      Jean-Claud ,

      I believe you will have no problem installing the C-core trans , I'm assuming you have
      the stainless chassis. I had to replace my chassis to accomodate the C-core trans but
      if you had built your Kit last year , I think you will have no prblems. Can you tell more
      about your hardwired driver board , it sounds like an interesting upgrade.

      Pet
      
      

      ---

      • Re: Kit 1 - Jean-Claude 08:35:04 09/30/06 (0)
        In Reply to: Re: Kit 1 posted by pet on September 30, 2006 at 04:42:20:

        Pet,

        Indeed I have the stainless chassis which is 400mm wide by 300mm deep. Do you think it would be correct for the double C-core trans ?

        Regarding the hardwirer driver board it is a wonderful experience. I have first implemented the standatd version (PC board, but I had ordered at the same time the Hardwire version with AN copper foil cond and tant's resistors. I had to drill the board (8 to 10 holes were missing).
        The difference between the 2 boards is not subtle.
        It took almost 4 months until the KIT one revealed its potential.

        Jean-Claude

        
        
        

        ---

Post a Followup: