|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
RE: "Hashy" .... yes
Posted by flood2 on January 9, 2017 at 15:34:40:
Other than another D2000Q, your ONLY options are the Stanton 7804DQ stylus or the D2400Q. The D4000 is for the XSV4000 (MM) and is not compatible since the UV15 is an MI design.
The D4500Q is for the XUV which is another MM design. The D4500S is for the low impedance XLZ body...
If the elastomer has hardened, there is no practical way to refurbish it since the tube crimping is one of the controls of compliance and "pinches" the elastomer by the desired amount. The tie-wire is soldered in position. Any attempt to disassemble is basically going to destroy it. Retipping is only viable if you are sure that the elastomer is still "good" and for preference you should only replace the tip itself and not the entire cantilever which will change the mechanical properties of the system from the design values.