Home
AudioAsylum Trader
Vintage Asylum

Classic gear from yesteryear; vintage audio standing the test of time.

For Sale Ads

FAQ / News / Events

 

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.

You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login


Login to access features only available to registered Asylum Inmates.
    By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username:

The Name that you picked or by default, your email.
Forgot Moniker?

 
 

Examples "Rapper", "Bob W", "joe@aol.com".

Password:    

Forgot Password?

 Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:  
Your Email:  
Subject:  

Message Comments

   

Original Message

RE: BIC 960 Turntable

Posted by Richard Steinfeld on December 30, 2011 at 06:27:49:

It's been a long time since I've done this, so memory is a little dim. You have to come in between the pulley and the bushing with oil on a toothpick or something even thinner. Don't overdo it because excess oil will seep down the motor shaft and may loosen the cup magnet, which will then slip intermittently on the shaft. It may be easier if you remove the pulley with an allen wrench.

This defect is maddening because the motor may seem fine until it warms up. The slipping magnet is an endemic failure on many BICs, and it can be repaired.

I can't recall what oil I used to use. I favor synthetics for staying in place longer than natural oils. The bottom of the motor shaft just sits on a leaf spring: there's no lower bearing, so the fact that the motor is semi-sealed is not critical as it is in the sealed motors of hundreds of Japanese cassette decks. If I have the motor apart to fix the slipping cup magnet, I'll give the bottom a clean and spot of new oil.